Arriva North West - Runcorn Depot
|
|
||||||
RE: Arriva North West - Runcorn Depot
(22/08/2012 18:14)trixmax2000 Wrote:Thanks for that!(22/08/2012 11:20)27701 Wrote:No my mistake it was 2948 in the workshops(21/08/2012 22:52)trixmax2000 Wrote: 2947 was in the workshops all dayIs 2947 now Runcorn-based? View my new Flickr Updated! |
||||||
|
||||||
RE: Arriva North West - Runcorn Depot
(22/08/2012 16:55)mathias Wrote:(21/08/2012 22:52)trixmax2000 Wrote: 3137 as now been fitted with a transponder so should send most the time on the X30 when not covering for one of the x1 branded ones These are fitted to buses working into Chester to lower traffic bollards in Chester |
||||||
|
||||||
RE: Arriva North West - Runcorn Depot
3137 was on the X30 today too |
||||||
|
||||||
|
||||||
RE: Arriva North West - Runcorn Depot
Owing to the Mathew St Festival on Sunday and Monday all of the 29-- Pulsar's should be working on the 79C if all goes to plan, With the other Runcorn routes been covered by the Cadets, |
||||||
|
||||||
RE: Arriva North West - Runcorn Depot
I had Pulsar 2 MX09 EKY (2940) on the X30, between Warrington and Chester, today. I have to say that this bus is an absolute shed! Its engine sounds odd, it rattles like hell at times and it vibrates and makes a loud humming noise - similar to Bootle-based CX58 FZK (2928), but that shed does does it after gear one... - when travelling at high speeds. Interestingly, passenger numbers didn't justify the need of a Pulsar 2 on my journey, but, needless to say, I've used this service many times in the past when numbers have justified the allocated Pulsar 2. The 79C is different because if a Cadet is full, there's only usually a 15-minute wait for the next bus, whereas if a full X30 refuses to pick-up passengers along the route, in most places, there would be no next bus for about an hour. I think that that's the point that trimax2000 is trying/has tried to make. View my new Flickr Updated! |
||||||
|
||||||
RE: Arriva North West - Runcorn Depot
(25/08/2012 18:53)27701 Wrote: I had Pulsar 2 MX09 EKY (2940) on the X30, between Warrington and Chester, today. I have to say that this bus is an absolute shed! Its engine sounds odd, it rattles like hell at times and it vibrates and makes a loud humming noise - similar to Bootle-based CX58 FZK (2928), but that shed does does it after gear one... - when travelling at high speeds. You hit the nail on the head with that one, Yes the X30 can have some light loads but in the main they can be some heavy loading the 10.03 ex Warrington comes to mind, Along with the first 3 trips into Warrington, So that takes the 3 buses needed for the service Ray |
||||||
|
||||||
RE: Arriva North West - Runcorn Depot
Yeah, ok, I get the point about the X30, still very much at a loss as to why they go on Busway Circulars and 110 though. Busway circulars, 10 minute frequency, allocated some Pulsars which I'm tempted to say don't carry a capacity load all day long. 110 gets allocated them and once again seemingly doesn't really justify them from my experience. The 79C has a 15 min frequency in theory, yet that is when it runs on time. You are seemingly responding to specific journeys on the X30 and catering for the loads it gets, why is the 79C any different, why not allocate larger vehicles on duties that quite evidently need it? I feel like I may as well be talking to a brick wall! At the end of the day, no matter what weather, rain or shine, I'd rather pay more money to get a Halton bus opposed to waiting another 15 mins for the next 79C. I'm sure others would feel the same. |
||||||
|
||||||
RE: Arriva North West - Runcorn Depot
The 79C is more frequent so in theory the loads can be more spread , the X30 isnt as frequent . |
||||||
|
||||||
RE: Arriva North West - Runcorn Depot
Read my last post! I have said I appreciate the X30 needs them, I dont see why busway circulars or the 110 needs them! |
||||||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 8 Guest(s)